Powder Properties
Gloss 70 minimum
Specific gravity 1.36 +/-0.05 g/cm3
Coverage at 1.0 mil 141.4 sq.ft./lb./mil
Storage 80°F
Shelf life 6 months
Cure Schedule 15 minutes at 375° F (at object temperature)
Test Conditions
The results shown below are based on mechanical and chemical tests which (unless otherwise indicated) have been carried out under laboratory conditions and are given for guidance only. Actual product performance will depend upon the circumstances under which the product is used.
Substrate and Pretreatment 1500 S Aluminium Test Panels
Film Thickness 2.0 Mils (Range is 2.0-4.0 Mils)
Cure Schedule 15 minutes at 375° F (at object temperature)
Mechanical Chemical and Durability Tests
Adhesion ASTM D3359 100%
Pencil Hardness ASTM D3363 HB-H
Impact ASTM D2794
Flexibility ASTM D552 1/8’’
Salt Spray ASTM B117 1/8” Creep at 1000 Hours
Humidity ASTM D2247 No Effect at 1000 Hours
Exterior Durability Requires topcoats for exterior durability
Additional Information
VP-300123-A is a thermosetting powder primer, exhibiting good mechanical strength and corrosion resistance. The product has good resistance to heat, yellowing, and moderate UV resistance. This product has been developed as a primer for use under wheel basecoats. VP-300123-A holds a material approval with DaimlerChrysler, as well as General Motors.
VP-300123-A holds the following OEM approval(s):
Daimler Chrysler General Motors
MS-PB59-1 9985586
Safety Precautions
When using, do not eat, drink or smoke. Do not breathe the dust. In case of insufficient ventilation wear
suitable respiratory equipment. For further information please refer to the specific product Material
Safety Data Sheet (MSDS) available on request from your local AkzoNobel sales office.
Disclaimer
IMPORTANT NOTE: The information in this data sheet is not intended to be exhaustive and is based on the present state of our knowledge and on current laws: any person using the product for any purpose other than that specifically recommended in the technical data sheet without first obtaining written confirmation from us as to the suitability of the product for the intended purpose does so at his own risk. It is always the responsibility of the user to take all necessary steps to fulfill the demands set out in the local rules and legislation. Always read the Material Data Sheet and the Technical Data Sheet for this product if available. All advice we give or any statement made about the product by us (whether in this data sheet or otherwise) is correct to the best of our knowledge but we have no control over the quality or the condition of the substrate or the many factors affecting the use and application of the product.
Therefore, unless we specifically agree in writing otherwise, we do not accept any liability whatsoever for the performance of the product or for any loss or damage arising out of the use of the product. All products supplied and technical advices given are subject to our standard terms and conditions of sale. You should request a copy of this document and review it carefully. The information contained in this data sheet is subject to modification from time to time in the light of experience and our policy of continuous development. It is the user's responsibility to verify that this data sheet is current prior to using the product.
Brand names mentioned in this data sheet are trademarks of or are licensed to AkzoNobel
